Page 1 of 1

3rd Party Nozzles

Posted: Thu Jun 23, 2022 5:23 pm
by mrinkunas
Given the disruption to the supply of Makergear hot end nozzles, can folks recommend 3rd party suppliers whose products will be compatible with my M2?

Re: 3rd Party Nozzles

Posted: Fri Jun 24, 2022 9:36 pm
by airscapes
Matterhackers had several MG nozzle sizes in stock last time I looked

Re: 3rd Party Nozzles

Posted: Wed Jun 29, 2022 6:02 pm
by rpollack
We do have more nozzles on order but it will likely be a couple of months before we get them :oops:

We currently have some nozzles in stock and we have some older style v4s that we'll make available. By older style I mean the tip is flat rather than rounded so they work fine but the rounded have slightly better print quality.