I used Meshroom to generate the 3D mesh, Blender for mesh clean up, and Simplify 3D for the slicing. I printed it on my good old M2 with an 0.25mm nozzle at 0.15 layer height.
The most difficult aspect was taking good enough photos and preparing the statues surface so Meshroom could work its magic. After 1157 photos and many failed meshes I finally got my camera settings and the surface preparation for the statue perfected -- the rest was simple.
The statue on the right is the original, the one on the left is printed. I am told the colors are different -- I am color blind so it is all green/gray to me.
let me know what you think.
Thank you,
Brent