Ask the MakerGear community for assistance...
-
bratan
- Posts: 27
- Joined: Thu Sep 28, 2017 1:42 pm
Post
by bratan » Sat Mar 02, 2019 6:41 pm
Hi,
I just installed 4 point spider upgrade on my M2 Rev D. I immediately noticed something very wrong when leveling bed. So I took of HBP completey and checked height of new spider from the top of the frame. It's about 5 mm lower on right side
![Sad :(](./images/smilies/icon_e_sad.gif)
I removed it from bearing, reinstalled but it's still very slanted. Spider itself looks ok. What am I doing wrong?
https://youtu.be/i7Y6v0IsM8g
-
bratan
- Posts: 27
- Joined: Thu Sep 28, 2017 1:42 pm
Post
by bratan » Sat Mar 02, 2019 11:14 pm
Took small level and check various parts of the printer. Top X platform is not square to the rest of the frame, that's the reason for this...
Going to see if I can shim Spider ...