I'm have yet another issue with my Rev D to 4 point spider upgrade.
It doesn't look like Z motor has enough torque to hold new heavier table. Especially if I use MIC6 plate. With plate it drops like a rock as soon as I go high enough. But even without MIC6 it stays up for few minutes and then drops Should I maybe increase voltage for Z motor? Or maybe there's a firmware setting for this?
https://youtu.be/gChjEp94iLQ
Z axis drops after spider upgrade
Re: Z axis drops after spider upgrade
Just realized it's happening when I hit the nozzle. I guess it's enough to make motor stall...