Printer stopped due to errors. Fix the error and use M999 to restart. (Temperature is reset. Set it after restarting)
Posted: Sat May 15, 2021 2:20 am
I've had this reoccurring issue plaguing one of my M2 Rev. E. Here is my previous thread: viewtopic.php?f=7&t=8154
The solution last time was repairing an partial break in the wiring harness causing the temp probe to mintemp. I repaired the area, and it continued to work for awhile.
Then it came back. I decided it wasn't worth another repair, and replaced the entire upper wire harness. This also fixed it for some time, but now it's back again. Could it be a break in the wiring harness again? Why would this printer be eating through the wiring harnesses like this? This is the newest of my 4 M2's, and has by far the least print hours on it.
Any ideas?
Cameron
The solution last time was repairing an partial break in the wiring harness causing the temp probe to mintemp. I repaired the area, and it continued to work for awhile.
Then it came back. I decided it wasn't worth another repair, and replaced the entire upper wire harness. This also fixed it for some time, but now it's back again. Could it be a break in the wiring harness again? Why would this printer be eating through the wiring harnesses like this? This is the newest of my 4 M2's, and has by far the least print hours on it.
Any ideas?
Cameron