Going back to v4 extruder

Ask the MakerGear community for assistance...
Post Reply
jcspball13
Posts: 98
Joined: Tue Jul 21, 2015 12:49 am

Going back to v4 extruder

Post by jcspball13 » Sat May 22, 2021 12:53 am

Could use little help; bought a used m2 rev d with v4 hotbed; the person I bought it from installed a different extruder, but I would like to go back to the original makergear one. Is it as simple as reinstalling the extruder and flashing the firmware to rev d?

Thanks!

User avatar
sthone
Posts: 897
Joined: Tue Jul 08, 2014 8:25 pm
Location: Connecticut
Contact:

Re: Going back to v4 extruder

Post by sthone » Sat May 22, 2021 8:26 pm

Yes it should be... just make sure you have the correct firmware. If the Z switch is at the top of the printer it should be a D or older but, If the switch is at the bottom it's probably an E or newer. They have a firmware selector on their site because the stepper motors can be different also so double check that to be sure.
____________________________________________________
See my projects at https://www.theneverendingprojectslist.com

Post Reply