After many hours of printing, my Y stepper has finally died-
I have the older m2 with the 12/19v that came with the v3B hotend.
Can anyone tell me the specs on the stepper so I can order a new one?
Thanks
Specs on older m2 Stepper motor?
Re: Specs on older m2 Stepper motor?
Not sure how up to date it is but this id from the Makergear Wiki
"The X and Y motors are standard, 1.8°/step stepper motors, that have belt pulleys with a GT2 profile and 18 teeth. A GT2 pulley with 18 teeth will have a circumference of 36mm, so one full revolution of the pulley will drive the mated belt 36mm. So 200 full steps = 3200 microsteps = 1 full revolution = 36mm. The firmware uses values of [micro]steps/mm, so the firmware value is (200 * 16) / 36 = 3200 / 36 = 88.89 steps/mm (88.88888888 repeating - 88.88 and 88.89 are both acceptable, though 88.89 is slightly closer)."
and replacements can be found in the Makergear Site.
"The X and Y motors are standard, 1.8°/step stepper motors, that have belt pulleys with a GT2 profile and 18 teeth. A GT2 pulley with 18 teeth will have a circumference of 36mm, so one full revolution of the pulley will drive the mated belt 36mm. So 200 full steps = 3200 microsteps = 1 full revolution = 36mm. The firmware uses values of [micro]steps/mm, so the firmware value is (200 * 16) / 36 = 3200 / 36 = 88.89 steps/mm (88.88888888 repeating - 88.88 and 88.89 are both acceptable, though 88.89 is slightly closer)."
and replacements can be found in the Makergear Site.
____________________________________________________
See my projects at https://www.theneverendingprojectslist.com
See my projects at https://www.theneverendingprojectslist.com
-
- Posts: 42
- Joined: Fri Apr 11, 2014 10:06 pm
Re: Specs on older m2 Stepper motor?
Thanks sthone,