Initial Z-height in Quick Start
Posted: Sat Dec 12, 2020 3:50 pm
I just replaced the electronics board on my M2E, reloaded the Marlin firmware, found everything running in the correct direction, homing correctly etc, BUT.
The Z level reached during the Quick Start exercise is more than an inch beneath the nozzle tip. In the past, this initial level has been more like 1/4 inch.
i assume that there must be a number for this height buried somewhere in the Marlin code. Is it there, and if so where?
The Z level reached during the Quick Start exercise is more than an inch beneath the nozzle tip. In the past, this initial level has been more like 1/4 inch.
i assume that there must be a number for this height buried somewhere in the Marlin code. Is it there, and if so where?