New to 3D printing, trying to hone in my settings
Posted: Sat Nov 12, 2016 11:57 pm
Hello all, I am still fairly new to 3D printing, have had some assistance with the good folks on Reddit's r/3Dprinting subreddit and have gotten to a point where I can get half decent prints, but I think, and they think, that my M2 rev E can do better.
First print and Second print
I copied a lot of the settings from the default files that came with the printer on the flash drive, I screenshotted my settings from S3D and uploaded to imgur
I would also like to know if anyone can help me with some custom gcode script, such as bringing the print bed down and forward at end of print so I can retrieve the print.
Again, any help you can provide is much appreciated, starting to run out of ideas on how to move forward with this and trying to not waste mountains of filament in the process!
First print and Second print
I copied a lot of the settings from the default files that came with the printer on the flash drive, I screenshotted my settings from S3D and uploaded to imgur
I would also like to know if anyone can help me with some custom gcode script, such as bringing the print bed down and forward at end of print so I can retrieve the print.
Again, any help you can provide is much appreciated, starting to run out of ideas on how to move forward with this and trying to not waste mountains of filament in the process!