Prints separating at joints...
Posted: Sun Nov 27, 2016 2:29 am
Hey everbody!! I am having a problem. Hopefully someone has some ideas.
I use a MakerGear M2. And most prints I am having great success. But with this new print, I am having an issue where at certain parts of my model it's separating and pulling up on corners. You can see it pretty clearly in this image. This print is about 12 cm wide and about 3 cm tall.
I am printing with ABS Plastic and the temp is 230 and 65.
Seems like no matter what I do it splits someplace during the print. Its clearly not sticking together well enough...but I dont know how to make it stick better as it goes. I can get it to stick to the bed just fine.
Thoughts?
I use a MakerGear M2. And most prints I am having great success. But with this new print, I am having an issue where at certain parts of my model it's separating and pulling up on corners. You can see it pretty clearly in this image. This print is about 12 cm wide and about 3 cm tall.
I am printing with ABS Plastic and the temp is 230 and 65.
Seems like no matter what I do it splits someplace during the print. Its clearly not sticking together well enough...but I dont know how to make it stick better as it goes. I can get it to stick to the bed just fine.
Thoughts?