I have a few questions before getting started with Ninjaflex. I've read a few of the forums but I am slightly unsure ...
1) hot bed temperature
Is 50C on the glass ok?
2) Should I mount my spool on the top
Do most of you top mount your spool or is it ok on the side? I remember seeing a post a while ago that I cannot find about someone that 3d printed a longer arm for where it spools the filament, does that help? If so where can I find that stl file
![Very Happy :D](./images/smilies/icon_e_biggrin.gif)
3) Cleaning my extruder
I have an extra extruder .. should I just dedicate that for Ninjaflex or is it not that big of a deal to clean it before different filaments? I am just nervous about ending up with a messy extruder that constantly clogs on me. I ordered a eSUN filament to use for cleaning.
4) Simplify3D Settings
I am seeing conflicting recommendations on this .. for example.
The extruder temperature recommended by the ninjaflex website is: 210 - 225ºC - http://www.makergeeks.com/ninja-flex-pla.html
I am seeing some people on here recommend 250c?!
![Uber Geek :ugeek:](./images/smilies/icon_e_ugeek.gif)
For the print speed I am seeing a recommendation of: 30 mm/s
When people on here are recommending 20mm/s (1150mm/min)
I am attaching some of the settings windows for my Simplify 3d if someone can point me in the right direction. What do I change and what to do I set what to what too.
Thanks!!!!
![Very Happy :D](./images/smilies/icon_e_biggrin.gif)
![Very Happy :D](./images/smilies/icon_e_biggrin.gif)
![Very Happy :D](./images/smilies/icon_e_biggrin.gif)
![Image](http://www.14113.net/3dprints/shot01.png)
![Image](http://www.14113.net/3dprints/shot02.png)