Marlin 2.0 firmware for M2 Rev E, latest bugfix

Have questions or comments about Simplify3D, Slic3r, Cura, Reptier, etc? Or wondering about which CAD software to use...discuss it here...
Post Reply
Posts: 2
Joined: Thu Nov 23, 2017 10:19 pm

Marlin 2.0 firmware for M2 Rev E, latest bugfix

Post by djw » Sun Apr 04, 2021 1:00 am

I recently upgraded my M2 Firmware to Marlin V2 Bugfix to get my Makergear M2 Rev E up and running 4/3/2021

I have these features enabled :
250,000 Baud serial rate Enabled- ive also had working up to 1 million baud - but I tuned it down until I know more
PID Tuned Hot end, and BED
Linear Advance Enabled
S Curve Enabled
ARC support enabled
Geetech LCD
SD Card
Serial buffer tuned size expanded to 32 commands with smaller command size width of 45 <- seems to work fine with cura and simplify3d
Custom Accelerations that I like - you need to change these
New default feedrates - you need to change these
Custom Steps per MM on several axis based on what Ive seen on my single M2 machine ive tested on.

Post Reply