Dual extrusion knot
Dual extrusion knot
Another dual extruder test. I would not count this as a success, since the bottom has lots of threads of the wrong color embedded in the layers from the support, but it looks okay from the top. I used the ooze shield for this, which was insanely hard to remove, but with a retraction of 16mm, it may not be necessary.
- Attachments
-
- dualknot1.jpg (92.64 KiB) Viewed 4747 times
-
- dualknot2.jpg (122.03 KiB) Viewed 4747 times
Re: Dual extrusion knot
That turned out nice.