This thing is
pure-D-spectacular Mike! It was the second thing I printed, after the Z-axis wrench set, and now I don't have to dart across the room to catch the bed when it drops! (Don't know how to modify G-code yet.)
I printed it using the settings below. (Picked it up off Thingiverse instead of seeing your zip here with the S3D settings.
Really wish I'd seen your S3D code.
![Rolling Eyes :roll:](./images/smilies/icon_rolleyes.gif)
)
PLA, 218°/0°, 3 perimeter layers, 50% infill, and because i was already having trouble with the PLA warping a bit and I wanted this to print perfectly flat....a 3-layer brim - 10 wide on hairsprayed glass.
Now let me warn other beginners about what
NOT to do......
never, under any circumstances, use a 3 layer brim on your print, unless you want to spend as much time carefully carving it away as it did to print the object in the first place! (Oh well, it
did stick to the bed.)
I attached it to the bed with Terrifically Tacky tape (red liner) and it really delivers! Many thanks!