Need some assistance getting started...post here...
-
insta
- Posts: 2007
- Joined: Tue Sep 16, 2014 3:59 am
Post
by insta » Thu Mar 05, 2015 10:00 pm
Vprints wrote:Finally got around to printing the snazzy Z knob. This may be a silly question, but how do you get the collar out of the stock knob? (Or does everyone just buy another collar?)
You have a new knob, right? You get the collar out destructively
Custom 3D printing for you or your business -- quote [at] pingring.org
-
jdacal
- Posts: 466
- Joined: Thu Jul 03, 2014 10:28 pm
- Location: Florida
-
Contact:
Post
by jdacal » Fri Mar 06, 2015 6:26 am
If I recall I was just able to pull up on the old knob and it slid off the collar, and was able to press the new one on. But its been a while, I might be wrong.
