I think many of the forum users here have "tenancies" to over-do. sometimes it's worth at laugh, share below.
Today I couldn't leave "Clean" at "Clean enough"
(not a before and after)
Sanding block > 320 Grit > 1000 Grit > 2000 Grit > 3000 Grit
Sanding by hand is so old school.
I think it's "good enough" now
Excuse me, while I go cry as I prime the nozzle with PETG.
When you cant leave good at "good enough"
- Matt_Sharkey
- Posts: 347
- Joined: Mon Oct 20, 2014 3:10 pm
Re: When you cant leave good at "good enough"
Just a sec before you prime it....need to check my mascara.
(Crickets.....didn't mean to scare everyone to death with a mascara reference - please feel free to laugh, add your own comments/ribbing. Man, when a joke flops.....)
Nice mirror finish there, Matt!
(Crickets.....didn't mean to scare everyone to death with a mascara reference - please feel free to laugh, add your own comments/ribbing. Man, when a joke flops.....)
Nice mirror finish there, Matt!
Re: When you cant leave good at "good enough"
I used to do that with my tips ... I still do that with the V4 tips once I've torched them. It looks great for photo ops
Season the nozzle while it's freshly sanded.
Season the nozzle while it's freshly sanded.
Custom 3D printing for you or your business -- quote [at] pingring.org
- Matt_Sharkey
- Posts: 347
- Joined: Mon Oct 20, 2014 3:10 pm
Re: When you cant leave good at "good enough"
Ha no flop jules, I was busy getting the thing calibrated again.Jules wrote:Just a sec before you prime it....need to check my mascara.
(Crickets.....didn't mean to scare everyone to death with a mascara reference - please feel free to laugh, add your own comments/ribbing. Man, when a joke flops.....)
Nice mirror finish there, Matt!
which brings me to another clogging problem (I just cant get a break.)
troubleshooting for a few hours then bed :/
Re: When you cant leave good at "good enough"
So when are you going to clean up that aluminum heating block?
- Matt_Sharkey
- Posts: 347
- Joined: Mon Oct 20, 2014 3:10 pm
Re: When you cant leave good at "good enough"
Tim wrote:So when are you going to clean up that aluminum heating block?
Didn't know that was a thing, I found a previous thread you wrote about it for the V4, how did that turn out for you?insta wrote:I used to do that with my tips ... I still do that with the V4 tips once I've torched them. It looks great for photo ops
Season the nozzle while it's freshly sanded.
Re: When you cant leave good at "good enough"
How did what turn out? Seasoning? I've only seasoned the V3b, the V4 doesn't seem to need it really.
Custom 3D printing for you or your business -- quote [at] pingring.org